Myograph Synapsis standard
The standard configuration of Synapsis Electromyograph is intended to be used during the wide range of the most popular methods of electromyography. It supports epicutaneous, needle and stimulation examinations with the full range of accessories (electrodes, wires, and tools).
Buy nowThe user is able to use one, two or four standard leads in the real time. The device can be efficiently used as in stationary conditions, as well as in the field (it doesn't require 220V power socket). The manufacturer implemented a wide set of innovative solutions in order to provide the highest quality of the electromyogram (EMG) with the lowest levels of both noise and interference.
Synapsis Electromyograph allows carrying the following procedures out:
The system supports various dental methods in order to evaluate the state of masticatory and mimic muscles, as well as all modalities of the event-related potentials.
Number of channels | 4 |
PC connection | USB |
Amplifier working band (at the level of –3 dB) | 0-10 kHz |
Sampling frequency for each channel | 40 kHz |
RMS-noise at the input | less than 5 mkV |
Measured signal amplitude range | 0,1 mkV – 200 mV |
AD Converter working range | 100 dB |
AD Converter capacity | 24 |
Bandwidth lower limit | 0 Hz - 1000 Hz |
Bandwidth upper limit | 1 Hz – 10000 Hz |
Power supply | +5 В (using USB-port) |
Electrical stimulation
Type | current |
Impulse amplitude | 0-100 mA |
Impulse amplitude control step | 1 mA |
Impulse length | 10 µs – 1 ms |
Impulse length changing step | 10 µs |
Impulse frequency | 0-50 Hz |
1. Hardware block (1 pc.)
2. USB cable (1 pc.)
3. Lead wire (5 pcs.)
4. Stimulating electrode with felt rings (1 pc.)
5. Plug-type stimulating electrode (1 pc.)
6. Main electrode wire (2 pcs.)
7. Wire for needle electrode (2 pcs.)
8. Lead electrode (10 pcs.)
9. Main electrode with the band (2 pcs.)
10. Needle electrodes (25 mm - 2 pcs., 50 mm - 3 pcs.)
11. Adapters for disposable EMG electrodes (8 шт.)
12. Package of disposable electrodes (50 pcs.)
13. Gel for electrodes (1 pc.)
14. Adhesive bandage (1 pc.)
15. Tape-measure (1 pc.)
16. Calibrating wire (1 pc.)
17. Special stand for the device (1 pc.)
18. USB-flash with the system software (1 pc.)
19. Operating instructions (1 set)